Got some stuff in today.....EK-DCP 4.0 and Res, EK Supreme HF, and XSPC 360

[mrcape]

Sweet. I have a similar tiny EK res and XSPC 420 rad and gentle typhoons (great fans). It's a great combo for my cpu at least. It was hard as hell to bleed the loop though, the rez was a little vortex. Mine had a top port and I used a length of tube to get it full to the top.

[Waterlogged]

Oh, thanks again Waterlogged and evryone else that chimmed in and helped with data and my parts selection.

I gutted an old CDROM drive to use in my drive bay to mount the pumps on. Just using the upper cover from the drive. It my not work out like I planned since the pump is a little larger than I thought and not sure I can squeeze 2 pumps onto it. But I thought it would keep the tubes short and make for a tidy case. Do you think the pumps would be better off at the bottom of the case in front of the fans?

NP Major. Is there a reason for 2 barbs on the res?

Sweet. I have a similar tiny EK res and XSPC 420 rad and gentle typhoons (great fans). It's a great combo for my cpu at least. It was hard as hell to bleed the loop though, the rez was a little vortex. Mine had a top port and I used a length of tube to get it full to the top.

There's a fix for this.

http://www.petsmart.com/product/inde...3172&lmdn=Fish

Just trim to fit the res and pop it in.

[Major]

NP Major. Is there a reason for 2 barbs on the res?



There's a fix for this.

http://www.petsmart.com/product/inde...3172&lmdn=Fish

Just trim to fit the res and pop it in.

Thanks! that is what I saw someone use and I can get it right down the street.

The lower barb is for my drain tube and plug.

[NaeKuh]

The lower barb is for my drain tube and plug.

lol.. i would of used a KL QDC.

But how you set it up looks nice as it is.

[QuadDamage]

Major,

You can easily mount a 120mm rad where the back exhaust fan is. I've squized one in the Cosmos S and HAF932. It's a little tight in the Cosmos S but it's doable.

Good stuff btw.

[Major]

Major,

You can easily mount a 120mm rad where the back exhaust fan is. I've squized one in the Cosmos S and HAF932. It's a little tight in the Cosmos S but it's doable.

Good stuff btw.

Thanks!

I thought about doing that but it didn't look like there would be room with the RX series, maybe a QP. I'll look at it closer and see. I still have the RX120 that I repaired that I could install back there.