Quote Originally Posted by klataa View Post
p.s. anyone is using watter block wich is mounted on this board? is it good?
Using the EK full cover block here and I am very please with it so far. I have the black acetal version, not as pretty as see through one but it still look nice with black compression fitting. The only 2 glitch I had was, you have to sand down the connor of the atx power connector. It is a very very tight fit. Also, big compression fittings wont fit because the chipset inlet and outlet position is too close to each other.

My temp was good, chipset never see pass 50c. I couldn't find the pwm temp or I think there isn't one on the this board lol. Cannot be sure because ET6 never worked for me, always been using everest to check temps on the MB.