program, utility- K10stat

[zir_blazer]

I should check that new version of K10stat, these screens are with the earlier one...







Right now I am running at 1 GHz @ 0.9V. I didn't tested for stability in any setting, just figured out when I can't get it lower any longer because the machine just freezes as soon as I apply a lower Voltage setting. I think than the Voltage could go an step lower at 100 MHz to just 0.600V, but at 0.5875 it freezes instantly. I didn't touch anything related to the Northbridge Frequency or Voltage, maybe I should mess with it because is a waste of resources get it running at 2 GHz when the Cores themselves just match a K6-II or so, same with the Memory Modules Frequency.
I recall than someone that I know than had an in depth knowledge of electronics said that transistors (Or some other component, or silice itself. I don't remember) could't work at Voltages lower than 0.6 or 0.8V because it was not enough current to open the transistor gate, or whatever it was. Does anyone knows about that? It means that I dd hit a physics limit?

I should also add than my AIIX4 620 got a CACYC Stepping (More precisely, CACYC AC 0937DPMW), so it means that it is a full Deneb. So far, I have been unable to even boot when using ACC and Unleashing Mode to see if I can get the Cache L3 to work.
I builded this computer yesterday (After a whole four years with an A64 3000+ Venice DH-E6 with an ASUS A8N-VM CSM), with this AIIX4 620, an ASUS M4A785TD-V EVO and a pair of 2 GB GSkill Ripjaws F3-10666CL8D-4GBRM.