Tried to get 4.2 with llc on and off.

With it off, I get bsod even with the vcore and vtt both set as high as 1.375.

(1.336 in cpuz idle)

Again, in cpuz the load goes down to 1.272 then I get bsod. Is it safe if I push vcore in bios to 1.4? Maybe that might be enough.

With llc on, Im using 1.33750 for both vcore and vtt, 1.328 idle in cpuz and it stays the same under load in cpuz and hwmonitor but in everest and probe it shows the vcore going upto 1.38-9 under load.

Are these safe voltages if it is going this high?

Will deffo get multimedter because I'm just not sure which to believe.

RoEy