Really need help....Please someone - Overclocking 920D0

[Leeghoofd]

Keep it on RoEY, at these voltage levels it won't harm anything. It's typical Rampage/Gene II behaviour that under load the Vcore rises above ya set value with LLC on ... don't worry about it... with the REX II measure it, software readouts are not always 100% spot on...

[chispy]

software readouts are not always 100% spot on...

^^ This +1, eventhought the voltages shown by software seems a little higher than usual on my past experiences with this board , i never saw a big jump in voltages like you under load with LLC enable using my DMM. Try using a DMM for read out correct voltages , i have never trusted software for that. Good Luck.

[RoEy]

Ok guys, thanks for all the help.

It's always done it from day one yet worked perfectly fine. I'd really like 4.2 but I think I need around 1.33vcore in bios for that, with LLC enabled and under load it goes upto 1.38, so everest/lcd poster says anyway. Would this be ok or not?Cpuz and hwmonitor say it stays roughly the same. Think I'll get a mulitimeter to check correct voltages.

So it's highly unlikely the board is faulty then?

Think I'm going to update to the latest bios too.

Thanks again,

RoEy

[RoEy]

Updated bios to 1802 and it may have slightly helped.

Just clocked to 4ghz, 1.325 for both vcore and vtt in bios. LLC Off / all power saving stuff off, spread spectrums disabled / speedstep disabled/ etc..

Cpuz read it as 1.296 idle and went down to 1.232 under load, so still a big drop but not as big as I was getting before.

As you can see in the image provided, cpu-z and hwmonitor read voltages the same but everest and asus probe read load voltages at 1.28.

I'd really like to run it with llc off if possible but can someone tell me if the drop looks any better, i,e, closer to normal?

Which 2 do I believe until I get multimeter?




Thanks again people,


RoEY

[RoEy]

Tried to get 4.2 with llc on and off.

With it off, I get bsod even with the vcore and vtt both set as high as 1.375.

(1.336 in cpuz idle)

Again, in cpuz the load goes down to 1.272 then I get bsod. Is it safe if I push vcore in bios to 1.4? Maybe that might be enough.

With llc on, Im using 1.33750 for both vcore and vtt, 1.328 idle in cpuz and it stays the same under load in cpuz and hwmonitor but in everest and probe it shows the vcore going upto 1.38-9 under load.

Are these safe voltages if it is going this high?

Will deffo get multimedter because I'm just not sure which to believe.

RoEy