Quote Originally Posted by Waterlogged View Post
A-Grey, you do realize that by using WW of any kind you are promoting a film to build up on your components that will hurt temps in the long run and is difficult to remove? It's fine for the application that it's recommended for but not computers.
Yes, I know but it isn't the same as what they are using in the car industry. I don't think that it leaves a film behind if it does we would have a lot of problems to print after cleaning the rubber blankets and ink rollers.


This is exactly why I wanted to wait to post it in the thread to see if the temperature stays the same after a few months with the Anchor Water Wetting Agent.

I've been using it for several months and the temperature doesn't seem to be worse than before but I'm going to run the same test again when my room temperature is exactly 18.5° Celsius again so I could see if there's a difference.