Foxconn BloodRage Shared BIOS Settings

[Tycun]

Can't pass Intel Burn Test on this board for some reason, someone can help me fix it?


Bios P09
CPU Features
PPM ...............................: Enabled
EIST ..............................: Enabled
CxE................................: Disabled
Execute Disable Bit ...............: Enabled
Virtualization.....................: Enabled
Hyper Threading ...................: Disabled
Active Processor Cores ............: All
Current Feedback Override .........: Disabled
Memory Settings
Memory Controller Settings
IMC Configuration .................: Enabled
Channel Congifuration .............: Independant
Channel Interleaving ..............: 6 Way
Rank Interleaving .................: 4 Way
Memory Timings
Extreme Memory Profile XMP ........: Disabled
DRAM Timing Control ...............: Manual
tCL (CAS Latency) .................: 8T
tRCG (RAS to CAS Delay) ...........: 8T
tRP (RAS Precharge) ...............: 8T
tRAS (Precharge Delay) ............: 24T
CR (Command Rate) .................: 1T
tRFC (Refresh Cycle Time) .........: 88
tWR (Write Recovery Time) .........: Auto
tWTR (Write to Read Delay) ........: Auto
tRRD (RAS to RAS Delay) ...........: Auto
tRTP (Read to Precharge) ..........: Auto
All Voltage Settings
CPU Voltages
CPU Core Voltage ..................: deafult
CPU Target Core Voltage ...........: 1.25625
CPU Vdroop Compensation ...........: Disabled
CPU VTT (UnCore) Voltage ..........: +100mv
1.8 PPL Voltage Setting ...........: 1.800v
CPU Clock Amplitude Ctrl ..........: 0.800v
Memory Voltages
DRAM Voltage ......................: 1.63v
DIMM1 Vref CA (Addresses) .........: 0.500 Default
DIMM1 Vref DQ (Data) ..............: 0.500 Default
DIMM2 Vref CA (Addresses) .........: 0.500 Default
DIMM2 Vref DQ (Data) ..............: 0.500 Default
DIMM3 Vref CA (Addresses) .........: 0.500 Default
DIMM3 Vref DQ (Data) ..............: 0.500 Default
Chipset Voltages
X58 IOH Core Voltage .............: 1.26v
X58 IOH VCCA 1.1V ................: 1.108v
X58 IOH VCCA 1.5V ................: 1.506v
ICH10 SB Voltage .................: 1.506v

CPU Turbo .........................: Always On
System Turbo ......................: Enabled
Clock Speed Control Center
CPU Bclock (FSB) ................: 200
QPI Link Fast Mode ..............: Enabled
QPI Multiplier ..................: x18
QPI Target Speed ................: 3605mhz 7.2gt/s
CPU Core Multiplier .............: x20
CPU Core Target Speed ...........: 4006 (EIST Enabled 21x200=4208mhz)
CPU Uncore Multiplier ...........: x16
CPU Uncore Target Speed .........: 3208mhz
Memory Bus Multiplier ...........: x8
Memory Bus Target Speed .........: 1604mhz
CPU Clock Skew ..................: 0ps
IOH Clock Skew ..................: 0ps


Here is the result in my asus board, 1.248v stable.