The E0 Q9550 SLB9V thread (finally!)

[ludehawk]

you can get it to 3.8 with ease do 448x8.5=3808 your memory should handle 890/2=448 which model number of memory you have post a link to newegg if they have it...I got some old xms2 corsair 2x1 running in my old ga-p35-ds3r with the E6750 just alittle oc'd to 3.4ghz nothing special which board model you got can you link that also from newegg?

i've been trying all afternoon to get something that actually boots.
I've had no problems with asus and gigb boards. This xfx crap is getting to me.
The only options I have are and the default settings along with several of the options for each:

Cell Menu

XFX J031 Over Clock Function Menu:
FSB Clock MHz: 1333 (set to anything)
Mem Clock MHz: 800 (set to anything)
Adjust CPU Ratio: (highest 8.5, set to any increment lower)

PC Vlotage Status (Love the typo!)
Then a warning about setting the jumper (it is set to OC).

CPU Voltage: default 0.0000v, options - .0125v - .3000v @ .0125 incr
Mem Voltage: def 1.90, option - anything to 2.5v .05incr
VTT FSB Voltage: def 1.2, options1.2-1.5v.025 incr
NB Voltage: def 1.24, anything 1.2-1.51 .04incr
SB Core Power: def 1.5v, anything 1.5-1.6v .3incr


Advance DRAM Config Menu:
Full Auto or:
Manual:
CAS Latency
tRCD
fRP
rRAS
tRRD
tRC
tWR
tWTR
tREF
1T/2T Mem Timing.


Here's my board: http://www.newegg.com/Product/Produc...82E16813141016 also http://www.xfxforce.com/en-us/Featur...therboard.aspx
Memory: http://www.newegg.com/Product/Produc...82E16820145184

I believe the mem is 5-5-5-18 @ 1.9v by default.

Thanks for the help!
Again, those are the only settings I have. No pciex settings, nothing.

[ludehawk]

This is really pissing me off, I can't touch any of the settings. Hell I don't think the q9550 is supported as the default volt setting is 0.0. I can't change anything other than the cpu voltage or it wont boot.

I might return everything and get an i7 920, intel board and some ddr3. The whole point of not going i7 was I didn't want to have to get new mem.