Can anyone rate the primochill Typhoon III?

[BoxGods]

What is the best way to run a loop?
There are no instructions and I am running resrvoir to CPU block and then rad and back to reservoir.
If I look at the back of the T3, where are the best places to put my barbs for one inlet and 1 outlet?
Thanks.

I am going to get to the directions this weekend. VERY sorry I have let that slide...just not a fun project and I am swamped getting everyone ready for QuakeCon.

Here is an explanation of the ports:



Ports A and B are OUTLETS.

Ports C and D are INLETS.

For a single loop configuration you can pick either A or B as your outlet and either C or D for your inlet. Any combination is fine.

For Dual loops use A and B as your OUTLETS and C and D as your INLETS.

In some cases you may want to run 2 lines in and one line out to suit your configuration. Either out port (A or B) is fine.

Hope that clears things up a bit.