[Project] :::Flow::: (SNiiPE's V2110) - Resurrected

[SNiiPE_DoGG]

Those panel look so good *-*

What screw size did you use to mount the EK Supreme ?

I drilled out the Thermalright metal AM2/AM3 backplate and tapped it to M4 threads

[twwen2]

I drilled out the Thermalright metal AM2/AM3 backplate and tapped it to M4 threads

Did you use standoffs between the hold-down plate and the mobo? If not, how did you maintain an even pressure (or tension) at each corner?

Looking good by the way!

[SNiiPE_DoGG]

Did you use standoffs between the hold-down plate and the mobo? If not, how did you maintain an even pressure (or tension) at each corner?

Looking good by the way!

to achieve pressure correctly I used the digital calipers to measure the thread length sticking out on the other side of the plate all are equal to within .05mm

[twwen2]

to achieve pressure correctly I used the digital calipers to measure the thread length sticking out on the other side of the plate all are equal to within .05mm

Gotchya