Can anyone rate the primochill Typhoon III?

[Diverge]

I have a question for you T3 experts. Can I take advantage of the higher flow by running anything in parallel with my setup. It consists of the following:

1 x Apogee GTZ
1 x D-Tek FuZion GFX 2
1 x MCW30
1 x Feser 360 rad
1 x Typhoon 3 w/ D5 variable

Right now i'm only using 1 inlet and 1 outlet port of the T3. Could I split anything up, that would benefit me, without actually running another rad?

[bluehaze]

Is there a way to tune the flow of the seperate loops? Thinking of getting one of these and putting a Mora 2 on one loop and HK 3.0 and 295 block on the other loop but with the Mora being so restrictive and the HK's being so free flowing i'm thinking it's not going to work without some way of tuning the flow?

My premise is that the Mora loop could run slower disappating more heat and the CPU/GPU loop could run faster keeping temps down. Being that they are both drawing from the same res the temps should still equalize. Not sure if there is any advantage to this though...

[Vapor]

I have a question for you T3 experts. Can I take advantage of the higher flow by running anything in parallel with my setup. It consists of the following:

1 x Apogee GTZ
1 x D-Tek FuZion GFX 2
1 x MCW30
1 x Feser 360 rad
1 x Typhoon 3 w/ D5 variable

Right now i'm only using 1 inlet and 1 outlet port of the T3. Could I split anything up, that would benefit me, without actually running another rad?

It's close to being a negligible gain....but putting the GTZ in its own subloop will net slightly higher flowrates (from ~1.33GPM to ~1.4GPM). Desipite how much the GTZ loves flow, that small boost won't mean anything for your temps.