UPDATE!... (finally)

ok so I got a shipment of parts yesterday so I spent the morning putting them together and... well I'll just show you

The parts


So this is the basic layout of the reservoirs I've had in mind for the last several freaking months but have been too broke to do anything about it until now


Pumps mounted to the wall like I want them. I was going to have them lower so they sit on the floor of the case but that only left about 1" between the outlet and my PSU which wasn't nearly enough for the tubing so I raised them up so the tube will go just above the PSU.




brackets mounted


What it looks like with everything mounted onto it


Closer look at the reservoir setup


Side view


Test fit into the case, pump view







Well that's it for today. I drilled the mounting holes to keep the wall in place and also put the bitspower (or w/e) fittings on my radiators. I need to get some flat black spraypaint to spray it and then I can mount it in there and connect all the tubes between the pumps, reservoirs, and radiators. I'll do that in a couple days though because I have work but there will be more updates very soon. Oh and I have the stuff to do my sleeving as well which will be a pain in the ass but worth it. Thoughts?