Abit AX78 + Phenom II beta Bios on Route

[Welshmangt4]

yes will give that a go in a bit .

side note , cpu-z gave me the same vcore as AOD as did anything i used tbh , always 0.97 . only thing i didnt check was the vcore in cpu-z after i had used the bios to increase it , AOD ( POS ) said the cpu vid was still 0.97 while the cpu vddc had increased to 1.92 from 1.55 ( + 0.37 increase .. ) if cpu-z still see's vcore at 0.97 then AOD must be correct ? if it see's 1.35 then i'll believe that instead .

[Welshmangt4]

ok put the 955be back in using V14 bios ( have 2 chips ) booted the same as before 0.968v core and x4 multi = 800mhz .. increases the core volts in bios to +0.37 ( max ) and now its showing 1.344 in cpu-z and abit eq so thats ok , just need the option for multiplier now , couple of programs that can do that for the time being though .. still only have PO state in bios too .

[soundood]

ok put the 955be back in using V14 bios ( have 2 chips ) booted the same as before 0.968v core and x4 multi = 800mhz .. increases the core volts in bios to +0.37 ( max ) and now its showing 1.344 in cpu-z and abit eq so thats ok , just need the option for multiplier now , couple of programs that can do that for the time being though .. still only have PO state in bios too .

ok things are a little better at least, you can use k10stat or my favourite for these things is Phenom msr tweaker,

you can pin that to start menu and set the multi and voltage on it, so in theory all you would have is slow boot.

and you followed what i said to the letter ehh? and cleared cmos inbetween CPU changes? and also loaded 'optimised defaults'?

i hate to sound anul, but this is soooo crucial to do at this point, as missing one of them will result in this kind of behaviour

[cdawall]

ok things are a little better at least, you can use k10stat or my favourite for these things is Phenom msr tweaker,

you can pin that to start menu and set the multi and voltage on it, so in theory all you would have is slow boot.

and you followed what i said to the letter ehh? and cleared cmos inbetween CPU changes? and also loaded 'optimised defaults'?

i hate to sound anul, but this is soooo crucial to do at this point, as missing one of them will result in this kind of behaviour

K10Stat wont work with the issue he is having all of the boards had this issue with the 955BE the mobo is not setting the CPUFID correctly and the chips will not respond to adjustments using K10stat unluckily the only thing that worked on my M4A78T-e was AOD to get it to clock. this means he will have to wait for a microcode update.