Full Tower from the past, they don't make 'm like they used to...

[Masterrer]

And another update:

my project stalled a bit, because of some problems at work (working 2 jobs tends to be pretty ty sometimes)

But I have some news for you!

Completed the radiator brackets:
120x2:


120x3:


Spent the whole week thinking how to mount the resevoir.
Today finally had time to do some work:



So, now I have to think how to route the rest of the tubing:

I was thinking along the lines:


But the problem here is that if I route the tubing through the mb i/o plate
I won't be able to use the sliding mobo tray without taking the loop apart
And I want to be able to slide out the mobo tray...

I'm having a hard time thinking of a way to pull this off, so I was hoping you guys could rescue me

[Bond Number]

Quick disconnects? Check Koolance

[Masterrer]

Quick disconnects? Check Koolance

Ok thanks, just read a couple of threads about quick disconnects.
And I'm afraid I can't go that route as it would add too much restriction to my loop (and my pump isn't that powerfull to begin with)

Masterer the pump flow in pic is wrong, the top is outlet and side is inlet.

other then that looks good

guess I need to RTFM more often...

is that silver coil in the res? retail? where from?
nice case and nice mods so far. i might have added another 240 between the upper and lower chamber. this will be nice when its done

Yes thats silver. Ebay. Thanks! I would also like to stuff as much rad as possible in there, but I'm affraid the PSU leaves little to no room for another rad. Thanks again, I will sure try to do my best!