@mikeyakame,
Yesterday, I enabled all the Channel Phases Pull-Ins running a Pl of 9 and Everest showed me the very same memory datas like I had with Phases Pull-In set on Auto running a Pl of 8.
Dear Mike, your knowledge about all that stuff is really legend
Later I tried to run all Phases Pull-Ins on enabled plus a Pl of 8 but my system refused to start. That means I could not run my system with all Phases Pull-Ins on Auto combined with a Pl of 7.
Looking back to the tFREs of my system the value of 4,399T should be the magic number (7800/(1000/564)= 4,399 isn´t it. That means I could change the tFREs with Memset vers. 4 to this value without causing memory instabilities, right?
But there is still another thing that really bothers me- I am having two sticks of the F2 9600 memory but with my settings right now I am running under the default speed. This board doesn´t have a 3:4 divider so I am not able to run a fsb of 460 MHz or higher combined with a high memory speed.
Do you have a recommandation -except reducing the fsb- to run a high memory speed plus a high fsb (460 Mhz or higher)?
Reply With Quote
Bookmarks