MA790X / MA790XT-UD4P 790X bugs fixes etc etc.....

[villa1n]

I tried MSR Tweaker too.. Now I just Installed AOD 3.2.. I hate AOD..for me to install and use it means theres something wrong lol.

the NBvid is controlable in AOD ONLY ,, I dont use AOD for overclocking so this sucks... After setting AOD and putting some stress on system i can see the higher temp loads from the ADDED NBvidvolts on the NB.

It seems the NBvid is NOT working in Bios. It can only be adjusted in AOD or Other software. Ive tried everything , Nada, even if i set it to the MAX Nada. CPUvcore is the only CPU volt setting we Have that worksand i have even set that to max. Yup it does Max on CPUvcore 1.81v

ONLY (Vcore is adjustable). I think teh GIGAguys think we may have been talking about the auto CPUvid or something instead of NBvid.This is so easy to see happen. NBvid does Not work period when trying to change in the BIOS.

O when i Raise the NBvid (USING AOD) , since the Bios does keep it locked @1.2vid I can get above 2400mhz on the NB.

I am not going to mess with the NBvid anymore or at least untill after another Bios. I dont need higher than 2000/2200nb ATm anyhow.

Its one thing to play with high volts Its another not knowing how high.


NBvid @! 1.36vid in AOD 3.2..
I dont use AOD to overclcok .I only use the BIOS to OC on MOBO . So to me this sad that AOD can make it work ,but Gigabyte says theres no problem with NBvid,,its a problem



Note: when using AOD ,, It will set the NBvid and you can use Everest to see it change as well as other sensor software.

Interesting, so Based on Daveburts testing, and what AOD seems to be showing, the NBvid is not being adjusted via bios. Funny how AOD is showing the correct NBvid voltage, but not cpu voltage...or does your chip run 3.7 at 1.3 volts?>!?!! Also my AOD says my memory is at 1.7v when i ve set it to 2.0 in bios.

I guess we ll see once we get the DMM readings

Ok, even more wackyness. When i try raising the voltages with AOD, ie raise nb volts to 1.36, apply... it comes up with the warning etc, then applies..but goes back to 1.2 on the scale...and everest shows the same thing.. no change?!