^^^Had a similar problem with my blades
First two sets died. One while running my first hyperpi run at only 1600mhz 7-7-7. Second after about 3 days of use and still only had them at 1800mhz at the time. Both times the stick in the third slot failed, so I replaced the board as well and now I've been running for about a month with no issues on this kit.
I am very curious to see that they have gren pcb's, not black. All 3 of my kits were/are black.
The DFI UT board is having some major problems getting elpida memory to work with a D0 revision on sticks not named "Dominator GT." I know Corsair used a proprietary PCB for their early revisions and those seem to be the ones that are working ok now. But all the other sticks are having some problems. And elpida benchmark scores clock for clock with the D0 processors vs. C0/C1's have some strange differences.
Right now, I can run the specs shown in my sig and thats about it. For some reason if I increase vtt past 1.23 set in BIOS, it is unstable. If I set VTT to 1.31 higher it simply will not post with C1 or CF. With a previous C0 2000 7-8-7-20-1T was not a problem with 1.65vdimm and 1.41vtt.
I'd be curious to see if the green pcb version works any better. Might give OCZ a call and see if they'll swap em out for me. Luckily i live about 30 min from their USA headquarters and they do will call RMA's
Reply With Quote
Bookmarks