Here's my idea for the res system. First of all, I was a dumb ass and had the inlet/outlet's mixed up in my head so the pumps positions are actually reversed of what they should be but that won't be too hard to fix. The two pumps will go over next to the PSU and I think I'm acutally going to put the 3rd between the rads in the front. I just think it'll look better. So here's the plan (awesome ppt drawings)
The two on the outsides are going to be the CPU and GPU loops which will use the two radiators in the front. Quick question though, will there be a huge performance drop if I go rad>res>pump>blocks vs. pump>rad>blocks>res? If not it would make this a WHOLE lot nicer looking...
I seperated the next two images so that it wasn't all clustered but this one represents the two loops that will be for the CPU and GPU (I plan on tapping and putting 45's on my D5's fyi)
And then this one represents the mobo loop. I think I might place it on it's back though so the outlet goes directly back out the wall again because this needs to go to the rad on the back of the case so I could run the tube along the bottom instead of going up then cutting across.
Thoughts?
Reply With Quote
Bookmarks