wow... awsome clock...
great chip...
wow... awsome clock...
great chip...
This Classified is incredible
nevermind the chip etc etc
this board is plain nuts!!!!!!
awesome stuff fellas
It was a good day’s experience we all had, I must say this combo has surprised me also guys as the very low temps in which it could boot and bench at are just un-heard off, I think the benchmark and Bclock says it all.
I cannot wait until we get our hands on this setup again as a lot of ln2 went into finding settings ECT so next time we should be able to run a few more benches.
As for the event I will be attending this is the info: (Scan event) All are welcome to come and watch the action.
I think we also got a boost from your patented NTTS (neoprene thermal transfer system) Paul.
Now you know how my secret on how we can get things to run that bit colder, it's all down to the NTTSOriginally Posted by raju
I think we also got a boost from your patented NTTS (neoprene thermal transfer system) Paul.
Fantastic! I have the Classified sitting here staring at me now. It's my current memory validation and gaming rig but it is just begging to be OCed. I'm just waiting on a 2000C7 kit and a D0.
Good luck at the SCAN event! Of course, we all want more pix. Someone use a spy cam and get a shot of Raja.
Yes, Yellowbeard, a tall rough man with a big yellow beard
i have the image already
1. The first rule of Bench Club is, you do not talk about Bench Club
2. The second rule of Bench Club is, you do not talk about Bench Club
3. If someone says stop, goes limp, taps out, the the benching is over
4. No bummers in the batcave, apart from unkie dave
5. One Bench at a time
6. No air, no water
7. Benching will go on as long as they have to
8. If this is your first night at Bench Club, you have to Bench
Nice work guys, looks like a lot of fun
With or without the :banana::banana::banana::banana:stache?i have the image already
damn Mike
they always make you wait for good stuff
Terrifying combo I might say, both the Classified and that small dirty bustard (I'm talking of course about the i7 920 D0 you guys have) are simply
Good luck on your future overclocking attempts guys !
Do you think we should chip in and buy Mike a set of Bladesdamn Mike
they always make you wait for good stuff
Believe it or not Mike the Elpida is kinda mandatory for stable BCLK benching over 240 on 2:8. The older modules sporting the early 1.65V stuff don't sit well with the i7 IMC up there. I suspect interchannel clock skews and drive strengths to be the issue, but we'll never get control of those as that is not how i7 rolls on that end. Everything is done on the 'matic so BIOS engineers only have to really apply start up timing for power cycles and MRC/MSR setting. Without the Dom GT, some of these benches would not have been possible.
later
Raja
Last edited by Raja@ASUS; 05-07-2009 at 08:32 PM.
Now you know how my secret on how we can get things to run that bit colder, it's all down to the NTTS
Speaking of temps, I'm thinking of getting one of Otti's pots. I think the extra mass will help us out below -150...
regards
Raja
hey,
Great review on anandtech! I saw you compared kingston memory vs dom gt.. you met a wall at 231Mhz with kingston?
Haakon
yeah, could not get the HT stuff to pass on 3d any higher. 2:6 was better for 32m and Wprime but did nothing to make the CPU test of 06 scale on the older memory.
regards
Raja
Wow quite an amazing 920 you have there
omg congratulations
Oh man, I am definitely looking forward to using this combo. Classifed, right here beside me, 2000C7 GT on the way, 920 DO on the way, and now I need a proper bracket for my SS LS-1 Jinu modded unit.
I am impressed...
My C0 cant reach -80C
-186 is amazing
Congratulations
Grats, -186c is amazing!
Last edited by eligray; 06-01-2009 at 10:07 PM.
e8600: 6261 mhz (LN2)
e8500: 5830 mhz (dice)
It's really unfeasible, unpractical, and for all intensive purposes... SHOULD NONE THE LESS BE ATTEMPTED!
Gio my UD5 hat 1200
but ....U Know what i mean ? :P
Classified is only board able to go over 250Bclk!
Nforce200 takes too much last from NB away
It mustnt handle GPUs directly
thats what this board gains for Bclk
and of course Genial Bios and everithing is perfect
just price !
My DDR2 Results:
Cellshock GMH 8500 2GB-1508MHz 2.74v vldt
Cellshock GMH 8500 2GB-1398MHz 4-4-4-12 2.74v vldt
Cellshock GMH 8500 2GB-973MHz 3-2-2-1 2.74v vldt
Cellshock GMH 8500 2GB-1000MHz 3-4-3-5 3.25v SP1M
Mushkin XP 8500 GMH 2GB-1300MHz 2.45v vldt
OCZ Reaper 1200MHz PSC-1406MHz 2.28v vldt
Dominator 8500 GKX 2GB-840MHz 3-2-2-1 2.5v vldt
Posting Permissions
Reply With Quote
Bookmarks