Quote Originally Posted by septim View Post
basically this thread shows people that parallel setup can work. it just depends on what you're using...
It also adds further reinforcement against the "Card 2 will get no flow!" myth that certain people have been pushing in regards to this type of tri-sli parallel setup.

Keep in mind however, that when you split a loop 3 ways each part of the loop (in this case each card) will get 1/3 of your overall flow. So you need to have a pump with good flow capacity (head pressure is less important in these setups because you are also making the resistance much much less than normal by going parallel). So there are certainly many things you still need to be careful of, just that you don't need to worry about each card getting different amounts of flow.