Originally posted by L337 M33P
That *looks* like the Sapphire 9600XT Fireblade? But has Hynix RAM?

Anyway, the card I have has the very same chips ('cept for the RAM, 2.86ns Samsung :p) and the RT9202s control VGPU and VDDR. The middle controller (6522CB) is for the VDDQ.

I found that out in this OCforums thread but haven't attempted the mod yet as my RAMsinks haven't come (damn radio spares)
Yeah it's a Sapphire 9600XT Fireblade, good spot

Right then, I need to get this straight in my mind before I attempt the mod(s)

For the VGPU mod I'm connecting pin 6 to pin 3 on the IC which is towards the blanking plate end of the board with a 10k VR right? Or am I connecting pin 6 to a ground point on the card (blanking plate, etc)

Vmem would be nice, but I'm already at 374mem so I'm *fairly* happy with that

I mainly want to get the VGPU mod done and then I'll look to work at the VMEM mod

One step at a time, my first vmod I did was on the Xabre 200, and that's the only card vmod I've done, ever

My soldering is up to it though I feel. Just need some clarification on exactly which pins I'm modding before I warm the iron up. Thanks for the valuable input into this thread guys