Fortron 530 watt PS

[mackanz]

I just recieved the FS 530 but the 12V measured from the ATX is a mystery.
The 3.3 was at 3.3, the 5V was at 5.55 and the 12V was at 11.02.

Now, can someone with the same psu, unmodded measure it as well?

I'm thinking that maybe with zero load, the 12V is that low? I know some psu's don't like zero load but this is a bit much.

As far as o know, the pot for the 12V is combined with the 5V on this psu, so when the 5V already is at 5.5, i can't do much with it.

TIA

Mac

EDIT**//

Looking a few pages earlier in the thread shows that Kunaak had the exact same problem and it proves that i was thinking right. This PSU needs some load to show the right voltages.
I have a few small pelts here, 70W each or so. Would it be enough to use those on the 12V and a few fans as well as a load? Or do i need to load all the lines?