Anyone actually install the HR-03GTX yet?

[wendigo4700]

So the enzotech mosfet's should work just fine (even tho they're a bit to big for the VRM's) but they just needed to get heated up a little???

I'm still reconsidering using them for my GTX285.

[Retro]

So the enzotech mosfet's should work just fine (even tho they're a bit to big for the VRM's) but they just needed to get heated up a little???

I'm still reconsidering using them for my GTX285.

I am testing the Enzotech mosfet sinks right now. I decided not to use any kind of thermal adhesive, just the included little itty bitty squares of 3M tape that come with the sinks. When first installed, they don't take much force to remove from the vrm's, but as kiparosu reported, they do bond better after heating them up as you use the card. I first installed them yesterday and they are still stuck to the vrm chips so far. Worth trying out, and there is no risk involved using the tape.
Thanks to kiparosu for the report on using the Enzotech sinks with the tape


I did some early testing with Rivatuner while running ATITool for about an hour (no overclocking on the card yet). Ambient room temp. 18C.


My GPU temps. under load maxed out at 51C.
The vrm's (phase 1-5 in R.T.) have hit a max. of 75C. in ATITool, averaging 67C under load.

Idle temps are about 38C for the gpu and 39C for the vrm's.

So far I'm quite happy with the outcome., with the expected drop of 15C or more on the gpu, and the vrms are running at very good temps.

Time for some overclocking, and voltage boosts