ASUS Striker II Extreme

[Sangrak]

More pll, try 1.54, 1.56, more nb, try 1.52, 1.54 vtt 1.32 1.34 Load line enabled.

On both my Striker II's, I don't need that much NB voltage for this configuration. In fact, I found it a bit unstable when I raised the NB to 1.50+ volts. Try 1.44-1.48 (that's with the over-volt figure into it.)

Increasing the PLL to 1.52-1.54 is a good move.

Edit: I've also found that by setting the vtt to 1.28, over-volts to around 1.31. If your board doesn't over-volt as much as mine, try setting vtt so it hovers around there.