Snapped a few quick shots, still not quite finished but you get the idea:
I just plopped the mosfet sinks on loose to show what they will look like.
Back of the card.
Two old dusty fans zip-tied on. Shows what the airflow potential will be with two good 120's installed.
Had the mobo out for some work. Note that the card is sagging a bit but it is fine when bolted into the case.
The project was not an easy one, and it cost a fair bit of dough, but the cooling results should be worth it. I had to drill out the mounts on the Enzotech nb sink for it to fit properly. Also had to use low-profile ram sinks in areas where clearance was tight.
Looking forward to getting this thing done next week
Reply With Quote
Bookmarks