What kind of VRM temps are you guys getting, I think I need to cool VRM 1 more as its about 10-20C different than VRM2! These are both located relative to where the stock fan was correct? My stock heatsink on this part is cut to just cover this side, but now with both cores loaded at 1.4v all the temps are find except the vrm1, vrm 2 loads about 80 and vrm 1 gets about 105!!!! I know that VRM's can take heat, but this seems like too much! Have you guys found a better way to cool these. All the other chips on my card have heatsinks attached, this is the only part that uses the stock heatsink, because I couldn't find a heatsink to efficiently cover all of the chips. Also have you guys had better luck leaving the fan on, or taking it off to lower vrm temps..... Thanks