Gigabyte EX58-UD5/Extreme Discussion Thread

[burningrave101]

I've gotten 211 x 19x to work but for my chip it requires a really high qpi/vtt. I think i was running like 1.75 - 1.79 qpi/vtt so I gave up on it.

I have seen others run it with under 1.4 qpi/vtt though. they probably have a better chip.

What are your settings?

I pushed the qpi/vtt all the way up to 1.55v and my DRAM to 1.75v and it locks up after a few seconds every time in Prime95. And I was running Small FFTs instead of Blend thinking it wouldn't push the IMC as hard. If mine requires more than 1.55V I don't think I'm going to even bother. That just defeats the purpose of me going to the x19 to lower the vcore.

Right now I'm running 21x191 at just under 1.4v and testing for stability. It's been stable at 1.4v but trying to lower it a notch or two. I keep jumping around between BIOS's to see if that helps any. I've tried F4j, F4m, and F5c. I'm back on F4m now.

[Lukee]

I pushed the qpi/vtt all the way up to 1.55v and my DRAM to 1.75v and it locks up after a few seconds every time in Prime95. And I was running Small FFTs instead of Blend thinking it wouldn't push the IMC as hard. If mine requires more than 1.55V I don't think I'm going to even bother. That just defeats the purpose of me going to the x19 to lower the vcore.

Right now I'm running 21x191 at just under 1.4v and testing for stability. It's been stable at 1.4v but trying to lower it a notch or two. I keep jumping around between BIOS's to see if that helps any. I've tried F4j, F4m, and F5c. I'm back on F4m now.

By chance, did you try raising your vcore a bit? Maybe it was a bit low.

Also, what are your multipliers for QPI/Uncore and memory.

Try 36x/15x/6x just to see if you can get the 211 bclk to work.