eVGA 9600GSO Dual-Slot volt mod?

[largon]

This thread is doomed and pencils are to blame. Mods work for some, but not for some. Makes no sense.
People trying to vmod without using a DMM or even without actual measuring points?



Anyways, here are the measuring points:



Someone should measure idle/load voltages from these points...

vMEM mod:


Pin#7 is ground, eg.

vGPU mod:



vMEM definitely works, vGPU may cause OVP tripping. Testing needed.
Alternative vGPU mod soldering point would be the pad immediately below the yellow dot.

Here's a vGPU mod that sets VID to 1.31250v:

VID mod pulled for now.


edit:
There is no reason why FB method wouldn't work. RT8802 has been modded succesfully in the past via the FB pin. The "issues" brought up in post #27 are present in all cards.

edit2:
VID mod pulled.