"White PCB" ASUS 790i Ultra mod

[DaMulta]

sorry to go off topic,

i have to ask, how is the OCZ cryo-z?

i just read about it and it showed some nice results for the price, but how is it for 24/7? i have not found much on that.

Ok I havent used it in a while so lets wait for temp talk. I myself have seen good results I would say....I have ran it for weeks at a time.

The one thing that makes me mad at it is. It does not always turn on. It gets to -35c or what ever when it turns on the PC. Instead it shuts down and I have to wait till it gets to -8c to flip it back on. It can do this over and over for an hour before it stays on....I asked fugger about how to remove that and he said remove the controller...I have no idea I opened it up and nope I could kill it too fast. I need to find some picks on what to do. I just want to flip a switch and it comes on.

At other times it starts just fine and could do so every day. Then you hit that day and you almost pass out waiting on it to just run...


When around 1.9v on a quad or even 2.0v the read out on the phase will say around -62 which is a lie but it's working very very hard I can feel the heat dump. The QX stays frozen(no temp reads coming from the chip) but I was going for 5Ghz never done that before. Then the man I asked(king)said I had my pll way over kill. I should of been doing less with it than more more and more.




So I hit 4.8Ghz with a QX9650. I can bench at 4.6 if I can remember right. But like I said about that damn pll.


If it wasn't for that I don't know what bug it is having I would love it. I almost have to leave it on if I don't want to get mad at it the following day.



Also my water setup makes more noise than it does. It's more low tone so it just really does not bug you.

[xdrift0rx]

Ok I havent used it in a while so lets wait for temp talk. I myself have seen good results I would say....I have ran it for weeks at a time.

The one thing that makes me mad at it is. It does not always turn on. It gets to -35c or what ever when it turns on the PC. Instead it shuts down and I have to wait till it gets to -8c to flip it back on. It can do this over and over for an hour before it stays on....I asked fugger about how to remove that and he said remove the controller...I have no idea I opened it up and nope I could kill it too fast. I need to find some picks on what to do. I just want to flip a switch and it comes on.

At other times it starts just fine and could do so every day. Then you hit that day and you almost pass out waiting on it to just run...


When around 1.9v on a quad or even 2.0v the read out on the phase will say around -62 which is a lie but it's working very very hard I can feel the heat dump. The QX stays frozen(no temp reads coming from the chip) but I was going for 5Ghz never done that before. Then the man I asked(king)said I had my pll way over kill. I should of been doing less with it than more more and more.




So I hit 4.8Ghz with a QX9650. I can bench at 4.6 if I can remember right. But like I said about that damn pll.


If it wasn't for that I don't know what bug it is having I would love it. I almost have to leave it on if I don't want to get mad at it the following day.



Also my water setup makes more noise than it does. It's more low tone so it just really does not bug you.

do you have any idea where i could find one of these things? i cant seem to find them anywhere on the net...

thanks btw