Quote Originally Posted by roger_h99.nor View Post
Nice work with the soldering iron there Jim

I've GPU modded my PCS rev.1 - much easier.

Card can bench at 960/vpu 1.35.
Think I've posted this earlier, but heck, it's Christmas
Thanks! Its not that the soldering points were too small to solder (did have a working microscope), but rather the dread of soldering the cable to one of them and then having a gust of wind detach the lot of it...

Yours is very clean and nice - good job! Wish I had rev1 for the clearly better quality... oh well - it was cheap at the time of purchase...

It is actually rather interesting that rev1 and rev2 are so different. 50Ohms vs 200kOhms for voltage regulation input for example

960MHz is impressive with these cards!

To terroristone: Airflow is the key and makes for bigger differences than I thought myself. I you not - I gained like 15C (as in -15C) by reversing ONE 120mm fan in my chassi, making it blow fresh air on my card instead of drawing air out.