Live MB OC Report :: ASUS Rampage Extreme

[mrcape]

I've got the micron D9GTS working nicely, but does anyone know the best settings for the Samsung ICs with this board? I have seen no improvement going from 401 to 801 bios. Is there another I should try? Am I missing something about Samsung and this board?

So far with the samsung I can get 2000 with CL9 trd7 but I can't get sub timings very tight and the efficiency sucks. Is there some different skew or trd/twister combo that I need to use with these? The GTS was smokin fast.

[DeathWalking]

Am I missing something about Samsung and this board?

So far with the samsung I can get 2000 with CL9 trd7 but I can't get sub timings very tight and the efficiency sucks. Is there some different skew or trd/twister combo that I need to use with these? The GTS was smokin fast.

I think what you're "missing" about the Samsung is that the Micron ICs are far superior.

[mrcape]

I think what you're "missing" about the Samsung is that the Micron ICs are far superior.

Really? I thought some were getting good results with these. I still have the opportunity to return these and get more micron.

[Smooth]

Really? I thought some were getting good results with these. I still have the opportunity to return these and get more micron.

Then take this opportunity !
Haven´t seen any good oc-results with samsungs for a long time ( and not one good/impressive result on DDR3 ).

[Zeus]

Then take this opportunity !
Haven´t seen any good oc-results with samsungs for a long time ( and not one good/impressive result on DDR3 ).

Nothing special but i did this with my Samsung HFC0 based Gskill mem:



Sold this mem cause it didn't like CAS 7 much over it's rated speed, not even with 2.05V.

[cheapseats]

This is the best I've had so far from the CS3222271 (CL7/960mhz), with 32m stability
vNB 1.65V (set) is quite reasonable for tRD8.

No OS tweaks or C/W for these runs.

I have also tried since with silver theme, maxmem, Large system cache and SPiTweaker,
and together they take about 8 seconds off the 10m09s time. May get a bit more with experience.
Quite useful as the subtimings won't really tighten at this memory clock (if I want to finish the run).
vDIMM levels already causing errors, and unusable above 2.0V (set)



600x7.5 / 5:8 / 333 strap / CL7 / CT Mod / tRD8 / tRFC 72

(599FSB boot + 1mhz FSB Joystick + tREF 16383T)







599x8 / 5:8 / 333 strap / CL7 / CT Mod / tRD8 / tRFC 72

(tREF 16383T)