What to do on a boring snowday

[Ozzfest05]

It will do the trick but where is the mounting mech please show us and you should lap it some more

[chew*]

Mounting and insulation is next on the list and is rather simple. The lip on the cap is sufficient enough, I use heavy duty plastic cutting board front and back mounting plates with armacell sandwiched in between.

As far as lapping well the CPU pot needs to have a base brazed on it, lapping with 1000 grit or higher would be pointless if i plan to emory cloth the bottom and braze a solid 1 1/2" x 1/8" solid stock to the bottom.

[mega*]

What do you use to clean your pots??

[chew*]

2000 grit wet sand, they arent even close to clean right now.I only hit them with 800 just to scuff them up a bit, this was used tarnished copper originally save the NB pot i'm making.

The inside you can clean with a silver polish method. Baking soda and vinegar IIRC. Rinse thourougly with hot water than take a blow dryer and heat it up really hot to evaporate any leftover water to avoid corrosion.