Quote Originally Posted by Kasparz View Post
I have seen some boards that doesn't like D9JNL/JNM, but GTR/GTS should do fine. Afaik i haven't seen any problems with Microns on x58 even knowing the fact that bios is still at very early stage.
Will you sell single sticks? Because I would like to go Tri-Channel soon.
Also, will the sticks need to have their SPD reprogrammed for Tri-Channel?

Quote Originally Posted by Rodriguez View Post
I have ordered 12Gb matched sets from CSX & will use 8gb now & 12gb with X58.

Check out the testing done with these sticks on X58 http://www.xtremesystems.org/Forums/...ghlight=diablo

This was done at 1.64, although higher voltage can be used & thus higher speeds.

Also take into account that there will be boards that will have an independent voltage for vDIMM like MSI & DFI, if early reports are true. This will enable users to use the same voltages as now.
Omg Rodriguez you going to be owning the memory benchmarks so bad
What ICs did they tell you they were going to have? GTR most probably...

Quote Originally Posted by Rodriguez View Post
Hello

the Patriot Viper 2000 2x2Gb use Samsung HCF0 chips,
Whats so amazing about this Samsungs? Are they any better than GTR/GTS ICs? if so, is it a big difference?