Quote Originally Posted by AKHandyman View Post
I have a Xeon 3360 that was lying around and I decided to put that in instead of the QX9770. I just got it to post but found out that 1 stick of my OCZ PC2 8500 (2x2GB) Reaper HPC died. I now have 4GB OCZ PC2 6400 (2x2GB) in and she has posted fine. I went right to ET6 and loaded up the 3 boost/max ... she's at 3600MHz (450x8) @1.344v ... this is WITHOUT any BIOS adjustment. Question ... does going into BIOS from here and fine-tuning change the ET6 set-up?
Yes it does. You will notice after change the value in ET6 the Power On value doesnt change.
Close the ET6 and open it up again you will see the value you just adjust.

Before you start anything adjust vcore, vpll ,vtt,vmch, vdimm manually. Some of it overvolt quite nasty if you set them on auto and OC.