A Positive Look at the Antec Nine Hundred (900) Case

[Defratos]

Well I've finally gotten around to taking pics of my 900, enjoy:

This little computer below was my first ever build so I'm still proud of it , but a change had to be made especially with the warmer climate over here.




Ok I didn't have to cut that large hole sitting between the original two cutouts, I'm a first time dermal user and got a bit carried away with it all, plus I was using the OP's guide lines which were based on an older version of mine, realized it when it was too late, but anyway it's ok because you can't see it once the MB is on

I've bought proper rubber sealing for the edges but this was a temporary solution which worked well and I haven't been bothered to change them.


First time I do anything related to using a solder or even cutting wires, quite chuffed with myself











Any comments or criticism's are welcome (well not too much criticism)