Real Temp - New temp program for Intel Core processors

**i43** · 11-12-2008, 05:58 PM

Thanks Unclewebb
here my low voltage run all same HW as my earlier post
except (adjustements followed by ' mr. rge ' instructions )
voltage set 1.1000v in bios (rather it show /jump/ 1.085 ~1.096 in everest /cpu-z but hope no deal with this )
C1E , SpeedStep - Enabled ( though ? i do see only C1E available in bios - i don't see SpeedStep (may be due to the lowest multi already set manual ? )
CPU TM Func - Enabled
Qx9650 /@ 2.0Ghz(6x333) / all other (auto) Rampage Extreme (Bios v0601)
Ambient - 23 C
Air cooled / Noctua NH-C12P / Open Air (table stand) |
(as mobo lay (flat) on the table, there shouldn't be any additional heat coming from VGA card or what so ever .. what may happen on normal desktop box/chassis)

still No manual idle calibration in RealTemp - leaved it for now .. TjMax (Auto) - 95C for 45nm qx9650
any way - these sensors never go below these values (25-25-21-27) since i first fired up this Yorkie
sure i will do some '' ghetto'' open window cooling '' later on a.s.a.p, just need some exact timing

when left ''home alone ''

and weather gets colder

about idle calibration from ' mr. rge ' post (for dual core)
he recommends to add current ambient /( for High end air (1fan).........................7C ) so consider quad at my scenario - then add more few degrees .. let say 9C .. OK i will tray later ... so do you think this is correct if i will calibrate al cores 34-34-34-34 C ?
I will try to calibrate for test purposes .. will see..

well, personally i am not much worried about these values/numbers
or have get used to live with them as they are..

--

not calibrated low volt screen shot attached
i shrink the attched screen .. but added also an external img. hosting links.

http://img521.imageshack.us/my.php?i...25244lchx8.png