Quote Originally Posted by Shocker003 View Post
Too late i have started the sanding and boy my fingers hurt like hell. For the past four hours, i have been sanding and the end is not even near
Ive lapped Fusion V1 and V2... They can be safely lapped flat with no bow..Just sand slow...

Ive been doing sanding X2/X4 cores for a while. Ive even EXIT port modded the holes on Fusion too for better flow...

Just drill the four corner exit holes to 3/8" for higher flow.Works with V2 just harder to drill the corners or you can use a roudtale file.







As for lapping,, make shure the Block is fully assembled then lap flat or it will bow when you put it back to gether..

You can do alot of small improvements with a fusion and still be able to use the Nozzel for INTEL chips.. If you use no nozzel you can open up center hole on the bottom for wider coverage of Center CORE CPU's..

I recomend the Split Nozzel for CORE2 Quads while using larger exet holes.

You dont need Extreme preshure to mount the block...Install as normal with factory hardware. When lapped ,, you may use a little less paste .A Nice super thin layer on each core is all that is needed with AS5 or MX-2.. Just remeber the AS5 takes longer to set when using water.