"ASUS P5Q Deluxe discussion".

[Leeghoofd]

Hi everyone, I've been reading this thread for a long time, but this is my first post. Now with 1406 bios, i've ventured higher to a setting similar to rusty, shown below:

I idle at 41 deg, and max out at 75 under the Intel Burn test.
Running Prime fft it maxes out at 63.

Is this too much voltage for 24/7 operation? I have it set for speedstep, and usually the CPU doesn't go above 50 deg.

JumperFree Configuration Settings
AI Overclock tuner: Manual
CPU Ratio Setting: Auto
FSB Strap to North Bridge: 333
FSB Frequency: 470
PCI-E Frequency: 101
DRAM Frequency: 941

DRAM Timing Control: Manual

1st Information :

CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15 -->18
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: AUTO -->55
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

DRAM Static Read Control: Disabled
DRAM Read Training: Disabled
MEM. OC Charger: Enabled
AI Clock Twister: AUTO
AI Transaction Booster: AUTO

CPU Voltage: 1.36250
CPU GTL Voltage Reference (0/2): 0.675 --> AUTO
CPU GTL Voltage Reference (1/3): 0.675 --> AUTO
CPU PLL Voltage: 1.60 --> 1.56
FSB Termination Voltage: 1.38 --> 1.22
DRAM Voltage: 2.1 --> 2.0
NB Voltage: 1.38
NB GTL Reference: 0.645
SBridge Voltage: 1.20
PCIE SATA Voltage: 1.60

Load Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : AUTO
NB Clock Skew : AUTO
CPU Margin Enhancement : Optimized

Advance CPU Settings
CPU Ratio Setting: Auto
C1E Suppport: disabled
Max CPUID Value Limit: Disabled
Intel® Virtualization Tech: disabled
CPU TM Function: Disabled
Execute Disable Bit: disabled
Intel SpeedStep Tech : disabled

Man you are really pushing hard on the volts... too hard to my liking... try the above and try to OC first with 4gb of ram, 8gb with these speeds could be pushing it...

[efok]

Man you are really pushing hard on the volts... too hard to my liking... try the above and try to OC first with 4gb of ram, 8gb with these speeds could be pushing it...

I dialed it back a little to 465FSB.

core voltage down to 1.34250

I can't get it stable with FSB termination voltage of 1.32
I'm testing 1.36 now