Bitspower Fittings and Swiftech GTZ

[Scubar]

Is that going to be a problem if you plan on using the 7/16" 5/8" OD fittings as thats what i plan on using ?

Would it still hit the logo. or will it be small enough to fit.

[BlueAqua]

The logo is just glued on. I just popped mine off and put it back down a few millimeters over. I didn't even think about it not sealing. I metal part of the fitting above the threads is now flush with the top of the block, but I'd hate to use that as my seal. I think I'll try another O-ring and see how that works.

[iowamoe300]

I have those bitspower transfer fittings on my gtz, and they thread in there fine and I have no problems at all.

[kadozer]

how about using BP compresion Fitting 3/4 OD on the side of EK RES?, what adapter do you recomended

Would like to know this as well.

[Scubar]

Im really worried now because i want to order a whole load of the 7/16" 5/8" BP compression fittings but i have a Swiftech MCRes and now a Swiftech Apogee GTZ and there is nowhere in the UK that does the adaptors.

Im now contemplating some normal 1/2" barbs but am unsure of whether to get the Dtek/DD or Swiftech ones. The Dtek and DD look like they have a recessed O-Ring so im guessing that could cause problems with sealing on the Apogee.

Are the Swiftech 1/2" Barbs a better choice to go with using 7/16" tubing and a zip tie.

[FrOzE]

So in order to prevent leakage, either 1 of the below has to be done?

1. Shifting of the Swiftech sticker
2. ST Adapter

For Bitspower 3/4" OD Compression barbs

[Waterlogged]

So in order to prevent leakage, either 1 of the below has to be done?

1. Shifting of the Swiftech sticker
2. ST Adapter

For Bitspower 3/4" OD Compression barbs

1. Yes
2. No, the ST adapter is for Swiftech products using their oddball NPSM 1/4" threads. The GTZ uses standard G1/4" threads.

[Scubar]

I have the Swiftech GTZ now and some BP 7/16" 5/8" Compression fittings and you dont have to move the sticker and they seem to tighten very nicely indeed. Ill be ready for leak testing soon but it seems the 5/8 compressions should be just fine on it.

[FrOzE]

Scubar... do give us some feedback...