UNOFFICIAL BIOSTAR TPower I45 M/B

[davefr]

I just picked up one of these boards and enabled the BIOS to turn on the board using a keyboard - "any key" or mouse click.

However it doesn't seem to be working.

Anyone else see this issue?? Is there another BIOS setting required?

Is there a more extensive guide to the BIOS anywhere? The manual is pathetic at explaining any of this.

TIA

P.S.
Using QX9650 and Corsair HX620

[Pcuser]

Latency seems to be average on this board
Lowest i could mange was 46.8ns but othertime with same settings i get 56-58ns

[Ace-a-Rue]

Latency seems to be average on this board
Lowest i could mange was 46.8ns but othertime with same settings i get 56-58ns

how do you have your rcomp ddr2 config and memory timings set?...auto?

[Pcuser]

how do you have your rcomp ddr2 config and memory timings set?...auto?

Config 2/3 or 4.
Timings on auto above 600mhz or 5-5-5-15 manually.
I found after i set the timings to CAS4 (ram can do up to 600mhz 4-4-4-4 on other boards)wont even save it in bios evn @ low mhz.After oc failed message i set the values again ram timings show as 3-3-3-8
Sometimes it works though

[Ace-a-Rue]

Config 2/3 or 4.
Timings on auto above 600mhz or 5-5-5-15 manually.
I found after i set the timings to CAS4 (ram can do up to 600mhz 4-4-4-4 on other boards)wont even save it in bios evn @ low mhz.After oc failed message i set the values again ram timings show as 3-3-3-8
Sometimes it works though

board to board can bring BIG differences on memory performance and top tier memory speed....never think that a different board will give you equal performance....i found this board did BETTER with my corsair dominator memory than it did on my previous ddr2 boards.

[thehinge1]

FWIW: I'm running am OCZ Reaper1066 4GB(2x2G) kit at 1074 right now, and have run my 2GB (2x1G) Reaper1150 kit at 1140 without issue in combination with an E7200.

[Pcuser]

board to board can bring BIG differences on memory performance and top tier memory speed....never think that a different board will give you equal performance....i found this board did BETTER with my corsair dominator memory than it did on my previous ddr2 boards.

Good point