How to set up GTL Ref Values for 45nm & 65nm

[Singh400]

Thanks for trying to explain, but after reading it through 10 times, I'm still left confused

I will keep at it...

[picnic]

Thanks for trying to explain, but after reading it through 10 times, I'm still left confused

I will keep at it...

I'm with you on this

Anyone want to dumb it down a bit more?

[andressergio]

Thanks Cryptik

I use .61ref on CPU to my Q6600 on my P35 board and .67red to the NB, seem to go up well on that values, achieved stable what it's on my sig

Cheers mate
Sergio

[Big Lar]

So in reality if I am getting this correctly, the Equation is for the Newer boards like the Formula correct? I think thats why my brain is twisted in a knot now.

Larry

[CryptiK]

So in reality if I am getting this correctly, the Equation is for the Newer boards like the Formula correct? I think thats why my brain is twisted in a knot now.

Larry

Yes the equation is what some boards like the M2F use, rather than just the multipliers. If you just have the multipliers, start with 0.635x for 45nm and 0.667x for 65nm, it's as simple as that.

It's only on the boards where they give you the Y value to modify that you need to use the equation to work out the appropriate Y value.