I recommend not to run linpack anymore as it is inconsitant and can cause damage to componets including CPU degardation if used many times over.Originally Posted by Willhub
Is that intelburntest good?
I just ran it through 10 tests and on the 10th the norm was different.
PL is at 10, ram is at 900, stock voltage, 5-5-5-15, made sure its 1:1 ratio.
ram stock is 1066Mhz 5-5-5-15 2.0-2.1V
CPU Voltage was at 1.344V for 4050Mhz.
1.344V passed orthos Small FTT's for 8 hours, blend stresses the ram too not the cpu more right?
Also will altering mem clock skews from auto to say 200PS Delay effect performance?
if you can prime Using Orthos Blend Test at least 12 hours then your good to go, of course if you can prime longer your goo to go.
Every Overclock i have ever done i used Orthos Blend Test prime and years agp prime95 Blend Test.
Keep Skew on Auto and whatever i stated before do so too and try that for Orthos Blend test which stresses both Ram and CPU.
Some ppl will do smallFTT for CPU for 8-12hrs and then Large for Ram 8-12hrs.
Like i noted above i have never had any issues if i was prime Blend for 12hrs or more... of course more is better.
We will hardly ever stress or use our systems as much as Orthos Blend will do in a 12 hour cycle..... i fold as well when i am good to go on this clock i will fold and never have had any issues.
My timings are 5-5-5-15 - 55 the other settings for timings is set at Auto.
All pullins are enabled and PL10 is being used.
Reply With Quote
Bookmarks