My board's voltage would normally drop about 0.05v from where I set it and 0.675 when under load. I did the pencil mod on the blue points very heavily because it wasn't showing at all after about 10 traces.

I'm now at the point where if I set the voltage to 1.25v it reads at 1.23 in the BIOS and 1.232 in CPU-Z at idle and under load. It's still below the BIOS setting but doesn't variate at all anymore. Basically what I'm asking is will it be safe to take the resistance all the way up to where if I set it to 1.4 in the BIOS it stays at 1.4 at idle and under load?

I just wonder if it's safe for there to be no variation in the voltages when under load. Thanks.