Hey guys, was hoping I could get some help, fitseries3 may amuse himself at my expense but that's fine. Basically using my system as listed in my sig, I have gotten into windows at various settings for speeds ranging from stock, 4GHz-4.6GHz, but never exactly stable. I have mostly been using the chip for benching so no stable has be found exactly, but the previous owner had it 24/7 10x400 1.368v after droop I believe. Currently priming at the following settings. Used the settings in red to bench. PC overall seems to be more stable with single card (tested with both 3870x2 and single 4850) then with both 4850's in CF. RAM I have never gotten to run at 1600MHz when changing settings, but has booted at 1600 when I first tried the board with my E8500 (did the XMP I guess, anyway board booted at I think 8x400 when I first put the E8500 in). Also have done benches at the settings in red with 2x1GB or 4x1GB, all the G.Skill HZ's. That is all I can think of for now. Thanks in advance.
Ai Overclocker Tuner: Manual
CPU Ratio Setting: 10.0 10.5
FSB Frequency: 400 430
PCIE Frequency: 100
FSB Strap To North Bridge: 333 Auto
DRAM Frequency: DDR3_1280 1434
DRAM CLK Skew on Channel A1: Auto
DRAM CLK Skew on Channel A2: Auto
DRAM CLK Skew on Channel B1: Auto
DRAM CLK Skew on Channel B2: Auto
DRAM Timing Control: Manual
CAS Latency: 7
DRAM RAS to CAS Delay: 7
DRAM RAS Precharge: 7
DRAM RAS Activate to Precharge: 18
RAS TO RAS Delay: Auto
Row Refresh Cycle Time: Auto
Write Recovery Time: Auto
Read To Precharge Time: Auto
Read to Write Delay(S/D): Auto
Write to Read Delay(S): Auto
Write to Read Delay(D): Auto
Read to Read Delay(S): Auto
Read to Read Delay(D): Auto
Write to Write Delay(S): Auto
Write to Write Delay(D): Auto
Write to Pre Delay: Auto
Read to Pre Delay: Auto
Pre to Pre Delay: Auto
All Pre to ACT Delay: Auto
All Pre to REF Delay: Auto
DRAM Static Read Control: Disabled
DRAM Dynamic Write Control: Disabled
DRAM Read Training: Disabled
DRAM Write Training: Disabled
MEM OC Charger: Disabled
Ai Clock Twister: Lighter
AI Transaction Booster: Auto
CPU Voltage: 1.375v 1.4825
CPU GTL Voltage Reference (0/2): Auto
CPU GTL Voltage Reference (1/3): Auto
CPU PLL Voltage: Auto Anywhere from 1.64-1.66
FSB Termination Voltage: Auto Anywhere from 1.24-1.3
DRAM Voltage: 1.9
NB Voltage: 1.56 Anywhere from 1.24 to 1.58
NB GTL Voltage: Auto
SB Voltage: Auto 1.2
PCIE SATA Voltage: Auto 1.5
Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew: Auto
NB Clock Skew: Auto
CPU Margin Enhancement: Performance Mode
EDIT: When I restarted to get the BIOS settings started BSOD just about every time now. Going to prime for a while with everything at stock.
Reply With Quote
Bookmarks