Quote Originally Posted by Villainstone View Post
WOW what are your BIOS settings?? Can you give me all the settings you are using, maybe I can get this POS higher than 450. Thanks in advance. That FSB is absolutely amazing BTW great job.
hope it helps


JumperFree Configuration Settings
AI Overclocking: Manual
CPU Ratio Setting: 6
FSB Frequency: 600
PCI-E Frequency: 105
DRAM Frequency: DDR2-1200
DRAM Timing Control: Manual
CAS# Latency: 5
RAS# to CAS# Delay: 5
RAS# Pre Time: 5
RAS# ACT Time: 15
TWR: Auto
TRFC: Auto
TWTR: Auto
TRRD:Auto
TRTP: Auto
DRAM Static Read Control: Disabled

Transaction Booster: Auto

CPU Voltage: 1.300
CPU PLL Voltage: 1.60
FSB Termination Voltage: 1.20
Dram Voltage: 2.20
NB Voltage: 1.70
SB Voltage: 1.05
Clock Over-Charging Voltage: 0.8
Load-Line Calibration: Enabled
CPU GTL Voltage Reference: 0.63
NB GTL Voltage Reference: 0.61
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew: Auto
NB Clock Skew: Auto

Advance CPU Settings
CPU Ratio Setting: 6
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
Vanderpool Technology: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled


this were the settings for a suicide shot. Also I was able to boot at 580-585 with only 1.25v in the northbridge . Im doing some OCCT test now to see how far I can go with this minimum voltage in the northbridge