Apogee GTZ

[Martinm210]

One thing I did notice, the quad core insert is worthless on the V2. I have to go back a run another couple of mounts with the insert to be sure, now that I have the new temp monitoring set up (thanks to your direction and advice), but everything I've seen so far suggests worse performance using the insert. At least on a Yorkie.

Have you seen that also?

andyc

Havn't tested it yet, only stock with the EK oring. I still have a few more stock runs to do, then I'm moving onto the "Overclocked" Nozzle/Bowing/Stepping" experiements..

[Martinm210]

LOL...yeah, you have to keep it fresh and fun. Thank God I don't have to drain my loop or wait for it to bleed anymore. I couldn't take much more of that.
Meet the triplets. Moe, Larry and Curley. Shimps on the bench
andyc

Yeah, I did something similar, but just some Zurn 3/4" hosebarb brass globe valves. If you look down the opening of these guys when open, there is no restriction at all. Then all I have to do is blip a few bubbles into the reservoir and I'm off and running again.

This also allows me to pull the entire loop away from the case when switching out blocks. Me and spilling go hand in hand...so over the workbench is much better than over the MB.

Now I just need to work on a techstation or horizontal case someday.....

[twwen2]

Now I just need to work on a techstation or horizontal case someday.....
[/IMG]

http://www.microcool.it/english/101prod.html

You know you want it

[NaeKuh]

http://www.microcool.it/english/101prod.html

You know you want it

oh dayam i want that.

okey so who do i need to kill in blingsville to get one?

[Martinm210]

http://www.microcool.it/english/101prod.html

You know you want it

Now why did you have to go do that....been going through keyboards left and right around here...need a waterproof one..!!

[nikhsub1]

Oh my,

I think I just felt something happen to me.

ROFL, Andy seriously, I was in a car wreck and my back is killing me. Please now