Quote Originally Posted by affiliate13 View Post
Here is a work in progress to get the VRM temps down some. Needs tweaking but maybe worth a look if anyones are too high.

Here

Its not finished as i need to record the temps better over longer testing and i need to fix problem with the angle of the VRM cooler to get even better contact.
1) You should use FurMark if you want to get maximum VRM temps. Run it in windowed mode at say 1280x1024, stability test setting. About 60-120 seconds in your VRM temps should be maxed out. This also allows you to watch the VRM temps in real time and take a screenshot.
2) I tried the exact same setup as you, with the HR-09 Type 2, but there is no way to make the sink contact the VRMs perfectly unless you shave it or put some plate in between. The damn thing is literally 2mm too wide at the base.

Good idea otherwise. Literally the exact same setup that I did with the HR-03 Good stuff, keep us posted on the results