*Official Retail G0 Q6600 Overclocking Thread*

[fatguy1992]

Yes, 1.28vcore is the lowest vcore achieved for 3.6 prime stable.

It's just the dfi board + gtl settings fine tune and a good batch q6600. When the GTL settings are in AUTO I would never get results near that. So is something that many ppl hate (too complicated) but can result is lower voltages and stable system if you have the patience.

I have run my Q6600 @ 1.28vcore @ 3.6GHz and I don't even change any GTL settings. Many cause IDK what they do etc.

If anyone could plz explain or link me to a guide that does.

[Jor3lBR]

I have run my Q6600 @ 1.28vcore @ 3.6GHz and I don't even change any GTL settings. Many cause IDK what they do etc.

If anyone could plz explain or link me to a guide that does.

Have you tried to run Prime95 on 4 cores for 10hours?

I'm talking about 8hrs Prime95 stable at that voltage not SuperPi... SuperPi means nothing.

[fatguy1992]

Have you tried to run Prime95 on 4 cores for 10hours?

I'm talking about 8hrs Prime95 stable at that voltage not SuperPi... SuperPi means nothing.

Nah i don't want to run at 3.6GHz for 24/7 but i'm think it would work.

BTW yeah i know Super PI doesn't mean anything, i just run it to show what kind of performace i was getting.