Wasn't stable @ 423 FSB so I put 412... I'll mess with it tomorrow.

For now it's stable with these settings:

Extreme Tweaker
Ai Overclock Tuner: Manual
OC From CPU Level Up: AUTO
CPU Ratio Setting: 09.0
FSB Frequency: 412
FSB Strap to North Bridge: 400
PCI-E Frequency: 105
DRAM Frequency: 824
DRAM Command Rate: 2N
DRAM Timing Control: Manual
CAS# Latency: 5
RAS# to CAS# Delay: 5
RAS# Precharge: 5
RAS# ActivateTime: 15
RAS# to RAS# Delay: 3
Row Refresh Cycle Time: 45
Write Recovery Time: 6
Read to Precharge Time: 3
Read to Write Delay (S/D) : 8
Write to Read Delay (S) : 3
Write to Read Delay (D) : 5
Read to Read Delay (S) : 4
Read to Read Delay (D) : 6
Write to Write Delay (S) : 4
Write to Write Delay (D) : 6

Write to PRE Delay : 14
Read to PRE Delay : 5
PRE to PRE Delay : 1
ALL PRE to ACT Delay : 6
ALL PRE to REF Delay : 6

DRAM Static Read Control: Enabled
Ai Clock Twister: Strong
Ai Transaction Booster: AUTO

CPU Voltage: 1.500v
CPU PLL Voltage: 1.5v
North Bridge Voltage: 1.41v
DRAM Voltage: 2.12v
FSB Termination Voltage: 1.4v
South Bridge Voltage: 1.050v
Loadline Calibration: Enabled
CPU GTL Reference: .067
North Bridge GTL Reference: .067
DDR2 Channel A REF Voltage: AUTO
DDR2 Channel B REF Voltage: AUTO
DDR2 Controller REF Voltage: AUTO
SB 1.5V Voltage: 1.5v
NB LED Selection: NB Volt
SB LED Selection: SB Volt
CPU LED Selection: CPU Volt
Voltimeter LED: Enabled
CPU Spread Spectrum: DISABLED
PCIE Spread Spectrum: DISABLED


I bolded out the changes. BTW latencies aren't that important to me as cpu speed.