Quote Originally Posted by hokiealumnus View Post
Don't see why not, but you'll loose the benefit of having extra heat-sinking (is that a word?) of the heat. Less surface area = less heat dispersion. Adding a fan on the PWM would help out, but you might want to consider adding that to the WC loop if it heats up too much on you.
It's too bad the only mosfet waterblock (that I know of) that will fit on this board is a MIPs cooler, which are hard/expensive to get state side. Always an option though.

Thanks, GeorgeVasil, for the pic. I might be better off researching to find other heatsinks that would fit on SB/mosfets since there will be a portion of the base missing where the pipe normally is. Or i could dremel the ends of the pipe to keep it in there.

I know there are Thermalright sinks that fit the SB, but are there any known heatsinks that fit the MOSFETS?